Author Topic: Started my build  (Read 5798 times)

Offline grapro

  • Jr. Member
  • **
  • Posts: 71
    • View Profile
  • Your Track: edmonton
  • Your Vehicle: 184" FED
Started my build
« on: December 09, 2013, 11:32:25 AM »
My kit has finally arrived and I have made my jig and started setting the pieces together, Fits pretty good together almost got the back half done just waiting on some more info from S and W racecars with a couple of questions, want to run a small block alcohol injected.

Offline GlennLever

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 2058
    • View Profile
    • The Lever Family Site
  • Your Best Time: 1/4 mile 7.950 at 165 MPH
  • Your Engine: Pontiac 461 Alky Blown
  • Your Track: Empire Dragway, NY
  • Your Vehicle: Front Engine Dragster
Re: Started my build
« Reply #1 on: December 09, 2013, 11:34:54 AM »
This will be a good one to watch. Thanks
Glenn R. Lever
Rochester, New York 14617-2012
My Cars https://www.lever-family-racing.com/

Offline probird

  • Jr. Member
  • **
  • Posts: 75
    • View Profile
  • Your Track: alberta
Re: Started my build
« Reply #2 on: June 14, 2014, 10:24:58 PM »
Keep us updated on how its going!
Would love to come by and have a look.

Offline grapro

  • Jr. Member
  • **
  • Posts: 71
    • View Profile
  • Your Track: edmonton
  • Your Vehicle: 184" FED
Re: Started my build
« Reply #3 on: June 16, 2014, 11:41:13 AM »
Hello
Another pipefitter from Calgary like me, Drop me a number and I can give you a call, busy this weekend at the Shriners show.  Maybe you seen my truck around green blown 29 ford pickup with bulldog beer painted on the side. Going set the dragster up to match.

Offline slingshot383

  • Full Member
  • ***
  • Posts: 146
    • View Profile
  • Your Best Time: 1/4 mi. 7.95 @ 168
  • Your Engine: Chrysler, alcohol, 528 cu.in.
  • Your Track: Gateway Motorsports Park (the Swamp)
  • Your Vehicle: Undercover Chassis 23T altered
Re: Started my build
« Reply #4 on: June 18, 2014, 03:43:31 AM »
Aren't those Irwin clamps a godsend?  We also use some clamps from the electronic section of the hardware store to clamp the 2" x 3" cubes to the surface table, small and out of the way.
Undercover 23T Altered, big block Mopar
Member of the Torque and Recoil Club

Offline probird

  • Jr. Member
  • **
  • Posts: 75
    • View Profile
  • Your Track: alberta
Re: Started my build
« Reply #5 on: June 28, 2014, 11:59:19 AM »
Check your messages.
I wont leave a phone number here.
Barry