Author Topic: How much front axle stagger on a FED?  (Read 5877 times)

Offline proriv63

  • Newbie
  • *
  • Posts: 34
    • View Profile
  • Your Best Time: TBD
  • Your Engine: Chevy, Gas, 422"
  • Your Track: Maple Grove
  • Your Vehicle: 205" Ken Keir
How much front axle stagger on a FED?
« on: November 27, 2013, 06:19:49 AM »
Will see mostly full tree and possibly pro tree.

Offline ricardo1967

  • Hero Member
  • *****
  • Posts: 578
    • View Profile
  • Your Best Time: No full pass yet.
  • Your Engine: Alky SBC 400
  • Your Track: Brown County Dragway (Bean Blossom, IN)
  • Your Vehicle: 173" FED

dreracecar

  • Guest
Re: How much front axle stagger on a FED?
« Reply #2 on: November 27, 2013, 08:56:02 AM »
Not so much about the tree, but whether you are running an index or all out. If you run all out then use stagger to stage shallow in the beams when you qualify, this lets you get a run at the start beam before the timers hit and will improve times and stage deeper when racing to shorten the track.
There is a debate on whether it helps with index or not. If your class does not allow DEEP STAGING the there is not that much bennifit to offset and the axle should be straight up and work on your staging to get it consistant. I race 7-0 and deep is allowed and I also run 2" of offset.My driver goes in deep everytime and what this does is puts the car in the same spot within an inch everytime because he stops when the light goes out and the track is as short as it can be without fouling.By being in the same spot every time eliminates a varible that can affect my times. With a 21" tire and 2"offset, by the time both beams just come on till the time one redlights is around 18" so going in deep cuts around 10" off the track

Offline masracingtd1167

  • Hero Member
  • *****
  • Posts: 1138
  • bill masiello Shelton Ct.
    • View Profile
  • Your Best Time: 7.40's at 181 on motor 6.94 at 192 nitrous
  • Your Engine: 394 chevy
  • Your Track: Lebanon Valley Dragway
  • Your Vehicle: 2003 Neil and Parks
Re: How much front axle stagger on a FED?
« Reply #3 on: November 27, 2013, 11:59:26 AM »
My car has 2 inches of stagger built in to it and I try to stage as shallow as I can . Usually I can go red this way on a pro tree but this can change from track to track due to different roll out . I adjust my car by raising or lowering my starting line rpm . I hope this helps . Bill

Offline slingshot383

  • Full Member
  • ***
  • Posts: 146
    • View Profile
  • Your Best Time: 1/4 mi. 7.95 @ 168
  • Your Engine: Chrysler, alcohol, 528 cu.in.
  • Your Track: Gateway Motorsports Park (the Swamp)
  • Your Vehicle: Undercover Chassis 23T altered
Re: How much front axle stagger on a FED?
« Reply #4 on: November 28, 2013, 05:59:15 AM »
If you're getting a redeye on a protree with a staggered front end, you are most likely pulling the tires out of the beam, and the stagger can't help that.
Undercover 23T Altered, big block Mopar
Member of the Torque and Recoil Club