Author Topic: Going Lenco and clutch  (Read 801 times)

Offline gordon

  • Newbie
  • *
  • Posts: 43
    • View Profile
  • Your Track: Sacramento
  • Your Vehicle: FED
Going Lenco and clutch
« on: April 06, 2023, 03:03:45 PM »
How much room do I need from axle centerline (9"ford) to backside of engine plate to fit an 8 5/8" can with CS-1+reverser and still install and remove it without moving engine in the process ?

Offline Calkins

  • Jr. Member
  • **
  • Posts: 69
  • On Any Sunday
    • View Profile
  • Your Best Time: 1/8th Mile - 5.77 @ 117
  • Your Track: Humboldt, IA - Humboldt County Dragway
  • Your Vehicle: 1997 Canode 225" Ex-Nostalgia Top Fueler
  • General Location: Midwest
Re: Going Lenco and clutch
« Reply #1 on: April 06, 2023, 04:55:00 PM »
Not really what you are looking for, but...  My car has a floater 9", believed to be a Mark Williams unit (which probably doesn't matter).  The engine is 40" out.  It is a former NTF chassis, so it most likely had a can and reverser in it originally.  I was trying to mount a full length Ford C4, and it was at least 3" too long.  The output shaft was hitting the female coupler on the axle.  I believe that trans is 32" long.
« Last Edit: May 08, 2023, 09:42:59 AM by Calkins »
Justin Calkins - Iowa Falls, Iowa  USA

UNDER CONSTRUCTION:  1997 Hal Canode 225" FED

Offline Paul New

  • Hero Member
  • *****
  • Posts: 745
    • View Profile
  • Your Best Time: 6.47 @ 214 MPH SBC
  • Your Engine: 387" SBC
  • Your Track: Woodburn Dragstrip
  • Your Vehicle: 2005 FED
Re: Going Lenco and clutch
« Reply #2 on: April 14, 2023, 08:53:07 PM »
I can tell you I run an 8 1/8 can with a 3 speed B&J and my engine is 42” out and I am tight barely can get the trans out.

Offline gordon

  • Newbie
  • *
  • Posts: 43
    • View Profile
  • Your Track: Sacramento
  • Your Vehicle: FED
Re: Going Lenco and clutch
« Reply #3 on: April 15, 2023, 07:16:31 AM »
That is kinda telling me a two speed lenco with Rev should fit with the 8 5/8" can without drama. Thank you Paul

Offline Paul New

  • Hero Member
  • *****
  • Posts: 745
    • View Profile
  • Your Best Time: 6.47 @ 214 MPH SBC
  • Your Engine: 387" SBC
  • Your Track: Woodburn Dragstrip
  • Your Vehicle: 2005 FED
Re: Going Lenco and clutch
« Reply #4 on: April 17, 2023, 07:40:17 PM »
No problem