Technical > Roo Man's Room

King pin / spindle bushings

(1/1)

Dunc the Funk:
Hiya

I need to get the king pin bushings replaced on our drop tube axle. I've taken the worst one apart, the kingpin was held in with a grub screw & it all came out easy. The kingpin mics at 0.75" & does not appear to be worn. The bushings are 0.75” inside diam & 0.75” length with an extra 1/16” flange on the bottom one to take the vertical load. The bottom one is shaped like a hollow top hat, fitted upside down. The top bushing is a simple cylinder.

Can anyone tell me where I can get replacement bushings from or what car these may have been off originally?

fuel749:
Anglia type spindles?  There's been a few manufacturers through the years and sometimes you can tell the manufacturer by the king pin boss and I know I've seen them with flanged bushings.  Being from outside the US you might see if you could find a machine shop to come up with something for you.

Dunc the Funk:
Yes, the spindles have Anglia sized wheel bearings, but the kingpin is smaller diameter than the few bushings I've seen advertised.

I've heard people talking about the standard being 11/16". I may need to talk to my local machinist.

Navigation

[0] Message Index