New Member

[Chuck466]

Good day everyone Chuck here, ready to get my first blown set up going everything is pretty much new except my long block I have been running for 18 years as a nitrous only set up, motor is all fresh new Callies double keyed crank 3.75, Molnar 5.7 rods, JE custom flat top pistons, LSM cam shaft, Coan fully built 400 trans, Can 5500 stall, All Mark Williams 9" out back 1990 S-15 @3400lbs.  410 ci, SBC just about the best of everything, TBS HH 8-71 mechanical injected, super excited to get to the track, I got a lot to learn with this set up..

[Chuck466]

Running a 3.89 pro gear with a Mickey Thompson slick 29.5X13.50

[Chuck466]

Here is a pic, I have had this since 2003

[Chuck466]

Engine bay

[Finnish Fireball]

Welcome Chuck, pretty truck you have and engine sounds like an serious piece. Whats your ET goal?

[Chuck466]

Right on thanks,  I suppose a good initial goal would be 5.0 in the 8th,  the first and only time out with this setup it went 5.50 right out of the trailer, with a 53 top pulley. So I now have a 50 on and a 48 and a 45 ready, I can't go any bigger then the 55 I have on the bottom, so would have to change out of the 8mm set up to get anything smaller up top..

[wideopen231]

Nice looking truck. I am thinking 5.0 should be east with your setup.  Welcome to site. Have fun because this stuff cost too much not to enjoy it.

[Chuck466]

Right on, thanks, I've been a pretty hard core racer for 30 years, going to Funny car Chaos tomorrow to get my 7.50 chassis certification tomorrow and enjoy some funny car racing and of course some FED too.