Author Topic: Torsion bar adjustment  (Read 2380 times)

Offline janjon

  • Full Member
  • ***
  • Posts: 208
    • View Profile
  • Your Best Time: 5.74/124 1/8
  • Your Engine: SB Chev, gas, 350ish
  • Your Track: Houston Motorsports Park
  • Your Vehicle: '65-ish 150" SBC/Glide FED
Torsion bar adjustment
« on: May 07, 2021, 02:07:04 PM »
Hello, does anyone have any pics or drawings of the inner workings of the VW torsion tube assembly commonly used on FEDs,
and any suggestions on how best to lock out all travel ?
Just keep the same amount of stuff on the right
as there is on the left. Seeing straight ahead is highly overrated....

Offline Dreamscometrue2020

  • Newbie
  • *
  • Posts: 5
    • View Profile
  • Your Best Time: None
  • Your Engine: Smc
  • Your Track: Kilkare
  • Your Vehicle: 70s FED/ 2013 Mustang
  • General Location: Midwest
Re: Torsion bar adjustment
« Reply #1 on: June 22, 2021, 06:36:06 AM »
I was gonna ask the same thing....the previous owner had welded tabs on each end...we were going to remove them

Offline fuel749

  • Full Member
  • ***
  • Posts: 159
    • View Profile
    • Dragster Supply
  • Your Track: New England Dragway
  • Your Vehicle: FED/Altered
Re: Torsion bar adjustment
« Reply #2 on: June 26, 2021, 05:42:21 AM »
The part of the VW torsion bar that provides movement is a stack of 1 inch-ish by 1/8" ish flat bars [been a while, can't quite remember] stacked together to form a square "shaft" that slides through the tube and is held in the center by a female square welded into the tube.  The arms have a female square that slides over the square shaft and locate in the end of the bar. 

    Some that I've seen have a 3 bolt cover over the arm where it slides into the tube that can be used to adjust the friction on the bar and slow down it's movement.  Figuring out a way to bolt that arm down tight is all you need to do.