Author Topic: 140-160" FED Build  (Read 3378 times)

Offline exracer

  • Newbie
  • *
  • Posts: 6
    • View Profile
  • Your Best Time: none
  • Your Engine: Chevrolet Alcohol 355
  • Your Track: none
  • Your Vehicle: none
  • General Location: Midwest
140-160" FED Build
« on: July 23, 2020, 08:24:35 AM »
I want to build a 140-160" " nostalgic" appearing fed, and I'm not having any luck with finding blue prints, or chassis builders who are willing to discuss the short wheel base.I would like to hear from some members who have built, and drove these cars . I would like to hear the pros, and cons. Thanks, Greg

Offline 225digger

  • Full Member
  • ***
  • Posts: 167
    • View Profile
  • Your Best Time: 7.43 185 mph in a RED
  • Your Track: numidia
Re: 140-160" FED Build
« Reply #1 on: July 23, 2020, 09:25:47 AM »
i posted in the other thread but here. its 200"....shorten it to how you want

https://swracecars.com/product/blue-print-200-front-eng-dragster/

Offline exracer

  • Newbie
  • *
  • Posts: 6
    • View Profile
  • Your Best Time: none
  • Your Engine: Chevrolet Alcohol 355
  • Your Track: none
  • Your Vehicle: none
  • General Location: Midwest
Re: 140-160" FED Build
« Reply #2 on: July 23, 2020, 09:40:11 AM »
Thanks, I will give them a try

Offline steve elzy

  • Newbie
  • *
  • Posts: 1
  • Slingshot Steve
    • View Profile
  • Your Best Time: N/a
  • Your Engine: Ford clevor
  • Your Track: BRI
  • Your Vehicle: 190 " fed The renegade
  • General Location: div 5
Re: 140-160" FED Build
« Reply #3 on: July 29, 2020, 04:28:15 PM »
I have MW print and a alignment bar for ford 9 inch and work in St.Paul. I went with MW because I thought it looked more the look of 60s. I did get my rollbars from Neil parks.I will not change you anything if I get them back. Just so you know it will cost more than you think and will take longer as well.Email me and I will give you my number if interested.
The good book says it was a slingshot that took down goliath