Author Topic: anti rotation connection  (Read 449 times)

Offline wideopen231

  • Hero Member
  • *****
  • Posts: 1565
    • View Profile
  • Your Best Time: 1/8 3.70@ 198 1/4 5.78@245
  • Your Engine: Hemi 526 ci alcohol
  • Your Track: Piedmont
  • Your Vehicle: 225 CMC FED
  • General Location: NORTH CAROLINA
anti rotation connection
« on: June 13, 2020, 05:32:57 PM »
 I don't guess there is any rule on how anti rotaion has to be bolted.
I need more ground cleartance. About only option is  lowering rearend and motor in chassis. I will nee to rework anti rotation which is wish bone under housing bolted to two tabs. I will have to remove tabs,welded bungs into middle rail under seat and bolt thru it. this will allow me to drop rearend 1" and get little more ground clearance at motor plate. I will also have to remount rearend which I hate but it is what it is. Lowering motor is no big deal except remaking motor front motor plates and cuttine and redrilling rear or m id plate.
I figure to get few more test in before heat get stupid hot and so rework whle it too dang hot out to be wearing a 20 suit and waiting on idiots to run a 500 hp car down a track they spend 10 minutes removing anything on it any where,
Relecting obama is like shooting right foot because it did not hurt enough when you shot left foot