Drag Racing Discussions > Rear Engine Dragsters

Replace the cage

(1/2) > >>

sandhopper2:
Not sure if I can get some more room by replacing the cage , but any Idea how much it would cost ? It maybe easier to do the entire thing , but could just the front tube and the side tubes be replaced ? I'm in SOCAL

THE FRENCHTOWN FLYER:
Every bit of $400 if you're lucky.
And you remove the old cage yourself.

Draw 3D:
I just had my roll cage redone to raise it a few inches and I supplied the pre-bent tubing from Mark Williams, around $350 funny car style, and had a local chassis guy cut the old cage off and fit and welded the new cage at a specific location and the chassis guy charged me $500 and did it in 2 days.

sandhopper2:
where to get some CM in socal ?

Paul New:
For a cage kit go here
https://neilparks.com/roll-bars.html or call up
--- Quote from: sandhopper2 on January 06, 2019, 07:46:06 AM ---
--- End quote ---

Navigation

[0] Message Index

[#] Next page