Technical > Dan Dishon's Transmission Den
CONVERTER ID HELP
(1/1)
dusterdave173:
Scored an unknown 8 inch--well built--only stampings are on the center of the nose where it goes into crank it says
B26
2936
3
Just was not sure what company stamped them there --just working to ID this thing
Thanks for the help!!!!!!!!!!!!!!
THE FRENCHTOWN FLYER:
Well,do you know what type of trans it fits? GM? Ford? Three bolt flanges or 4-bolt? What is the pilot diameter size? Spline cpunt?
THE FRENCHTOWN FLYER:
--- Quote from: THE FRENCHTOWN FLYER on December 04, 2018, 01:58:35 PM ---Well,do you know what type of trans it fits? GM? Ford? Three bolt flanges or 4-bolt? What is the pilot diameter size? Spline count?
--- End quote ---
dusterdave173:
Yea i know it is 8 in PG spline for Chevy that was not my question
I wanted to know what converter company stamped the numbers on the Hub--that way I can contact them about the inner workings
It is stamped on the center of the hub not on converter body like many--that has to be a "tell" of some certain company
Thanks
bikeguy307:
Wow what a strange place to stamp a converter, I dont know of any of the major companies that stamp there.
Navigation
[0] Message Index
Go to full version