Technical > Dan Dishon's Transmission Den

PUMP PRESSURE CHECK

(1/4) > >>

spitzerscott:
I have a TCI powerglide, I see a 1/8NPT port right in front servo cover angled downward.  Is this where I hook up my gauge to check pump pressure?  How much fluid will I lose when I remove the plug? 

bikeguy307:
That is the high clutch port, you will a small amount of fluid, not enough to worry about. It will only have pressure when in high gear.

spitzerscott:
So where do I hook my gauge to check pump pressure?  Do I need to remove trans-shield?

gregm784:
Servo cover for low gear
At tail housing seam for reverse

What case?  Stock? Reid? ATI?

gregm784:
1 is the reverse port - will have pressure in reverse gear
2 is the "low" port - will have pressure in low gear

Note: not all stock cases have the reverse port tapped & capped.

Navigation

[0] Message Index

[#] Next page

Go to full version