Author Topic: Minimum sleeve thickness  (Read 2231 times)

Offline wideopen231

  • Hero Member
  • *****
  • Posts: 1910
    • View Profile
  • Your Best Time: 1/8 3.70@ 198 1/4 5.78@245
  • Your Engine: Hemi 526 ci alcohol
  • Your Track: Piedmont
  • Your Vehicle: 225 CMC FED
  • General Location: NORTH CAROLINA
Minimum sleeve thickness
« on: June 07, 2018, 04:07:31 PM »
Ok have 2 TFX-92 solid blocks. Wondering how big I can go with bore? Guess question is how thin can sleeves in solid block be and still remain round.they are not going to leak reguardless.LOL
Relecting obama is like shooting right foot because it did not hurt enough when you shot left foot

Offline jeff/21

  • Full Member
  • ***
  • Posts: 186
    • View Profile
  • Your Best Time: 8.24
  • Your Track: any with-in a 6hr radius
  • Your Vehicle: fed
Re: Minimum sleeve thickness
« Reply #1 on: June 07, 2018, 04:22:55 PM »
i've never had a solid block you should be able to go big, check and see what pistons are available or go see at insidetopalcohol.com they must have people that have run that motor

Offline wideopen231

  • Hero Member
  • *****
  • Posts: 1910
    • View Profile
  • Your Best Time: 1/8 3.70@ 198 1/4 5.78@245
  • Your Engine: Hemi 526 ci alcohol
  • Your Track: Piedmont
  • Your Vehicle: 225 CMC FED
  • General Location: NORTH CAROLINA
Re: Minimum sleeve thickness
« Reply #2 on: June 07, 2018, 06:52:09 PM »
I have a post on inside top alcohol/Not many run these antiques any more. As for piston they are custom made so any size works and same cost.
Relecting obama is like shooting right foot because it did not hurt enough when you shot left foot

Offline jeff/21

  • Full Member
  • ***
  • Posts: 186
    • View Profile
  • Your Best Time: 8.24
  • Your Track: any with-in a 6hr radius
  • Your Vehicle: fed
Re: Minimum sleeve thickness
« Reply #3 on: June 11, 2018, 05:01:25 PM »
i see that you got your answer in the other forum i've gone there for info in the past

Offline wideopen231

  • Hero Member
  • *****
  • Posts: 1910
    • View Profile
  • Your Best Time: 1/8 3.70@ 198 1/4 5.78@245
  • Your Engine: Hemi 526 ci alcohol
  • Your Track: Piedmont
  • Your Vehicle: 225 CMC FED
  • General Location: NORTH CAROLINA
Re: Minimum sleeve thickness
« Reply #4 on: June 13, 2018, 05:44:55 AM »
Yep looks like 4.375or 4.400 is doable . If going to spend money for new pistons might as well go bigger and add another 1/4" of crank plus cpl points compression. Figure can always drop compression if need with gaskets. hAVE .030 TO .090 sitting here.
Relecting obama is like shooting right foot because it did not hurt enough when you shot left foot