Author Topic: Transbrake  (Read 1414 times)

Offline wideopen231

  • Hero Member
  • *****
  • Posts: 1274
    • View Profile
  • Your Best Time: 1/8 3.70@ 198 1/4 5.78@245
  • Your Engine: Hemi 526 ci alcohol
  • Your Track: Piedmont
  • Your Vehicle: 225 CMC FED
  • General Location: NORTH CAROLINA
Re: Transbrake
« Reply #15 on: July 05, 2018, 06:36:54 AM »
Backing up can mean bad band or out of adjustment.
Relecting obama is like shooting right foot because it did not hurt enough when you shot left foot

Offline spitzerscott

  • Jr. Member
  • **
  • Posts: 83
    • View Profile
    • Ogg Motorsports
  • Your Best Time: TBA
  • Your Engine: 336 Small Block Chevy
  • Your Track: Osceola IN
  • Your Vehicle: Spitzer225 RED, Alcohol SBC
  • General Location: Northern Indiana
Re: Transbrake
« Reply #16 on: July 07, 2018, 09:19:37 AM »
Dan, Where do I hook up my gauge by the servo? I was told I could torque the low band to "x" inch pounds and then back off "x" amount, can you fill me on the numbers?  We want to work on this tomorrow, any help will be greatly accepted.

Offline gregm784

  • Sr. Member
  • ****
  • Posts: 295
    • View Profile
    • Means Racing
  • Your Engine: 387 Dart/Brodix
  • Your Track: Famoso Raceway
  • Your Vehicle: 1997 Stirling 200" FED
Re: Transbrake
« Reply #17 on: July 10, 2018, 09:18:41 AM »
I'm not Dan, but most guys like to torque them to 72 In #s, the back it off 3 1/2 turns.

Most servo covers have an 1/8" pipe tap plug in the cover, gauge goes there.
Greg
El Dorado County, CA
www.meansracing.com

Offline spitzerscott

  • Jr. Member
  • **
  • Posts: 83
    • View Profile
    • Ogg Motorsports
  • Your Best Time: TBA
  • Your Engine: 336 Small Block Chevy
  • Your Track: Osceola IN
  • Your Vehicle: Spitzer225 RED, Alcohol SBC
  • General Location: Northern Indiana
Re: Transbrake
« Reply #18 on: July 10, 2018, 06:09:15 PM »
Thanks Greg,  that is exactly what we did, try it soon!

Offline bikeguy307

  • Full Member
  • ***
  • Posts: 216
    • View Profile
Re: Transbrake
« Reply #19 on: July 15, 2018, 08:24:11 PM »
Depending on the valve body anywhere from 185lbs to 230lbs.