Author Topic: powerglide VW starter  (Read 2523 times)

Offline sandhopper2

  • Newbie
  • *
  • Posts: 44
    • View Profile
  • Your Best Time: none
  • Your Engine: vw 1915 turbo
  • Your Track: none
  • Your Vehicle: 205" RED
  • General Location: west coast
powerglide VW starter
« on: May 25, 2018, 06:10:41 PM »
Looking for info / pictures or measurements to add a vw starter to the bellhousing of an aluminum PG 1967 el camino trans

Offline bikeguy307

  • Full Member
  • ***
  • Posts: 241
    • View Profile
Re: powerglide VW starter
« Reply #1 on: May 25, 2018, 07:29:41 PM »
I have seen a few set-ups like that but never puad attention to how it was done. My you can find info on a VW fourm.

Offline bikeguy307

  • Full Member
  • ***
  • Posts: 241
    • View Profile
Re: powerglide VW starter
« Reply #2 on: May 25, 2018, 07:45:22 PM »
From what Im reading on some other forums they are cutting a "pocket" at the 12 o' clock position in the powerglide case and mounting the starter to the adapter. Also read one where they adapted a standard chevy flex plate to the VW engine.

Offline sandhopper2

  • Newbie
  • *
  • Posts: 44
    • View Profile
  • Your Best Time: none
  • Your Engine: vw 1915 turbo
  • Your Track: none
  • Your Vehicle: 205" RED
  • General Location: west coast
Re: powerglide VW starter
« Reply #3 on: May 29, 2018, 05:54:34 PM »
Thanks I have been all over the VW sites and no luck yet
The pocket is cut at 12 o clock but before I screw it up I would like to know some measurements
Thinking of taking a VW bus Bellhousing and cutting out the starter pocket then adding that to the PG

Offline bikeguy307

  • Full Member
  • ***
  • Posts: 241
    • View Profile
Re: powerglide VW starter
« Reply #4 on: May 29, 2018, 07:37:58 PM »
You may contact Coan Engineering in Kokomo In. I remember seeing a VW powered Comp car years ago at the U.S. Nationals with a Coan sticker on the trans.