Author Topic: mechanical injection question  (Read 2002 times)

Offline L79_Acadian

  • Jr. Member
  • **
  • Posts: 62
    • View Profile
  • Your Engine: Just a little 355 Chevy
  • Your Track: none
  • Your Vehicle: 2013,160" CenPen Speed Shop (Worm)
mechanical injection question
« on: March 24, 2018, 03:26:53 PM »
Hi Spud, its been a while, but I have another question regarding injection. I am finishing a project, 388 stroker SBC.Anyways, I have a Enderle 80A-1 pump for the bug catcher on top of a converted GMC 6-71. I plan on running alcohol. I also have another Enderle 80A-1 to put onto another project with a 6-71 and a Hilborn 4 port on gas. Now the question, I have two 3-way shut offs, one with -8 fittings and the other with -6 fittings. I also have a return loop kit that has -6 lines on it. Would the -6 line ( from the pump to the barrel valve)  be sufficient to supply the barrel valve with enough fuel in the blown alcohol setup on the 388 Chevy? Or would it be better suited on the other project with the hilborn on gas?
 Thanks Spud, hope you can help me out, again
 Roger
« Last Edit: March 24, 2018, 07:10:26 PM by L79_Acadian »

Offline wideopen231

  • Hero Member
  • *****
  • Posts: 1910
    • View Profile
  • Your Best Time: 1/8 3.70@ 198 1/4 5.78@245
  • Your Engine: Hemi 526 ci alcohol
  • Your Track: Piedmont
  • Your Vehicle: 225 CMC FED
  • General Location: NORTH CAROLINA
Re: mechanical injection question
« Reply #1 on: March 30, 2018, 06:47:53 PM »
Gas require less fuel especially injected.Where as blown fuel require lot more fuel.Gas gets #6 and alky get #8. JMO
Relecting obama is like shooting right foot because it did not hurt enough when you shot left foot