Classifieds (Please No Dealers) > Wanted to buy

alum small block

(1/2) > >>

hotrod316:
looking for a good used alum gm  small block (410 motor)
moving on up!
thanks
steve m

alkyal:
Did you find a Block? I have a Rodeck that has NOT been Blown Up. It will probably need new Sleeves as its @ .030 over. I will have to check. Has SBC cam bearings. Believe the rear cap is Wet Sump. If interested please reply with a contact number. I am in Ohio. Price will B reasonable as I dont have a real use for it and cant use for our purpose. Thanks Al

hotrod316:
Al, yes we found one but always looking for a back up block  how many nickels?
 

alkyal:
Will check some dimensions and post with asking price by Weds  Al

alkyal:
What I have is an Older Rodeck. Std size Babbit SBC cam Brgs. The Liners are worn .030. Would clean-up @ .035. The rear cap is a dry Sump. Main Caps-Studs and nuts-washers are there also. The block has some damage from a rod-s failure in #1 ad #2. Was run like this. Asking 750.00 plus shipping from Ohio. Block has Rodeck 350 Plus cast into front. Mains are 400 size.

Navigation

[0] Message Index

[#] Next page