Author Topic: Mopar alloy 8 3/4 idenity ?  (Read 831 times)

Offline George

  • Hero Member
  • *****
  • Posts: 505
    • View Profile
  • Your Best Time: 4.50 ET. .9901 60'. 157.mph. 1/8 mile
  • Your Engine: SBC 23 degree. 100% Alky. 375CID. 6:71@ 1/1
  • Your Track: Central Illinois Dragway. Havana , Illinois
  • Your Vehicle: FED 223" 6.00 Cert. (owner)
  • General Location: Midwest USA
Mopar alloy 8 3/4 idenity ?
« on: July 06, 2017, 07:05:55 AM »
I have an alloy Mopar 8 3/4" housing. I expect is quite old. It broke and was replaced by an iron unit several years ago. It is stamped above the fill plug 61400 and 4661/ 2380. The 2380 may be 2390 as the stamp isn't quite complete. I would appreciate any information. Thank you. George

Offline dreracecar

  • Hero Member
  • *****
  • Posts: 1483
    • View Profile
  • Your Track: Bakersfield
  • Your Vehicle: 7-0 pro dragster
Re: Mopar alloy 8 3/4 idenity ?
« Reply #1 on: July 06, 2017, 08:17:05 AM »
Pictures would help a lot
 Mickey Thompson made a mag one  and Donovan made an aluminum version
Numbers are not much help

Offline George

  • Hero Member
  • *****
  • Posts: 505
    • View Profile
  • Your Best Time: 4.50 ET. .9901 60'. 157.mph. 1/8 mile
  • Your Engine: SBC 23 degree. 100% Alky. 375CID. 6:71@ 1/1
  • Your Track: Central Illinois Dragway. Havana , Illinois
  • Your Vehicle: FED 223" 6.00 Cert. (owner)
  • General Location: Midwest USA
Re: Mopar alloy 8 3/4 idenity ?
« Reply #2 on: July 06, 2017, 08:37:00 AM »
I will try and get a picture posted . Thank you. Bruce