Technical > Spud Miller's Cave

Motor dies

<< < (4/8) > >>

GlennLever:

--- Quote from: hotrod316 on May 15, 2017, 10:26:45 AM ---thanks Glenn sound just like our problem
what pump did you use?

Bruce 6 gmp
75 inches long tube with 12 inch of #12 hoses
1 inch od
.822 id

we are going to put a baffle with a doors
Does the baffle go all the way to the top of the tank?

we are trying to come after you Glenn and the rest of the pro comp gang  :) :) :)

--- End quote ---

Just got home from Gateway, will look it up tomorrow.

hotrod316:
thanks all cutter her up this am :-*

GlennLever:
This is what I started out with. The pump was later replaced with another one as this one did not have enough power.



I put the small tank in stream in the return line to the tank. That way once it has been started the first time at a race it is always full until you empty it at the end of a race.





The feed to the pump comes off the bottom of the tank.



The line from the pump goes into the distribution block for the injectors, with a check valve.



Now I can give the engine a shot of alcohol anytime I need to.

I cannot find a shot of the pump, I will have to go over to where the dragster is stored and get a shot for you.

hotrod316:
thanks Glenn :)

dreracecar:
Gimmicks, lots of cars dont use that--whats so different??

Navigation

[0] Message Index

[#] Next page

[*] Previous page