Technical > Spud Miller's Cave
dual injectorators
tenyears:
I need a lot of help at this point.
I have a pair of injectorators, kinda rough alittle pitting inside bowls. I think im missing a lot.
is there a parts diagram and system diagram to help get me started on rebuilding and setting these up?
I don't have any nozzles or jets or pill or high speeds or pump.it needs all new line hose.
im using these on a 1000hp ,8500rpm. 110 gas and street pump gas. clutch,lenco.
thank you for any help,or advise.
dreracecar:
I believe Waterman was involved with these, might want to go there.
Pitting should not be an issue, all those were was a fuel injector with an accelerator pump so you would not have to run fat on the bottom with gas like a straight fuel injector
hemidakota:
good luck with the gas. we have one on alky and love it. waterman was no help setting it up. they have been bought out and still have parts available. james barton jabarton5618@gmail.com is the contact info I have. what pump and throttle bodies do you have? if there is any info I can help with ask. I am no professional but with help im sure you can get in the ball park.
hemidakota:
http://www.frontenginedragsters.org/forum/index.php/topic,1040.msg7350.html#msg7350
tenyears:
--- Quote from: hemidakota on September 17, 2016, 07:32:27 PM ---good luck with the gas. we have one on alky and love it. waterman was no help setting it up. they have been bought out and still have parts available. james barton jabarton5618@gmail.com is the contact info I have. what pump and throttle bodies do you have? if there is any info I can help with ask. I am no professional but with help im sure you can get in the ball park.
--- End quote ---
james barton is a dead end. ive seen that info over the years and its been a dead end from day one. nothing out there.
thanks for info.
Navigation
[0] Message Index
[#] Next page
Go to full version