Author Topic: Tube splice length  (Read 3624 times)

Offline msundstrom

  • Full Member
  • ***
  • Posts: 120
    • View Profile
  • Your Best Time: 7.45 @ 182 in 1/4
  • Your Engine: NA Injected 505 BBC on 45%
  • Your Track: Woodburn Dragstrip
  • Your Vehicle: FED
  • General Location: Washington Coast
Tube splice length
« on: July 09, 2016, 11:32:05 AM »
When spicing two tubes of the same diameter with an inside tube sleeve is there a minimum length for the inside tube, I found lots of aircraft info but don't know if that applies to dragsters?
Thanks
Mark S

Offline fuel749

  • Full Member
  • ***
  • Posts: 159
    • View Profile
    • Dragster Supply
  • Your Track: New England Dragway
  • Your Vehicle: FED/Altered
Re: Tube splice length
« Reply #1 on: July 09, 2016, 11:44:35 AM »
Minimum 3" on either side of the joint. Plug welds within 1/2" of the end of interior tube. 1/4" diameter minumum. I make the plug weld holes a little bigger, I like to see the interior tube after I weld it.

dreracecar

  • Guest
Re: Tube splice length
« Reply #2 on: July 09, 2016, 01:13:00 PM »
You should also split the inner sleeve so that it expands and takes up any slop between the 2  that you are splicing together

Offline msundstrom

  • Full Member
  • ***
  • Posts: 120
    • View Profile
  • Your Best Time: 7.45 @ 182 in 1/4
  • Your Engine: NA Injected 505 BBC on 45%
  • Your Track: Woodburn Dragstrip
  • Your Vehicle: FED
  • General Location: Washington Coast
Re: Tube splice length
« Reply #3 on: July 09, 2016, 03:22:24 PM »
Split one side and spread it out?

dreracecar

  • Guest
Re: Tube splice length
« Reply #4 on: July 09, 2016, 03:51:55 PM »
Because the tubing is under tension anyway it will expand on its own

Offline msundstrom

  • Full Member
  • ***
  • Posts: 120
    • View Profile
  • Your Best Time: 7.45 @ 182 in 1/4
  • Your Engine: NA Injected 505 BBC on 45%
  • Your Track: Woodburn Dragstrip
  • Your Vehicle: FED
  • General Location: Washington Coast
Re: Tube splice length
« Reply #5 on: July 09, 2016, 07:09:00 PM »
Makes sense. Thanks for the help