Author Topic: welding ?  (Read 11254 times)

Offline Mrs Esterhouse

  • Newbie
  • *
  • Posts: 25
    • View Profile
  • Your Best Time: 8.65 1/4 mile
  • Your Engine: SBC
  • Your Track: none
  • Your Vehicle: fed
  • General Location: midwest
Re: welding ?
« Reply #15 on: January 08, 2016, 03:37:08 PM »
Thanks again for all the ideas, It's pretty cool to be a part of this group.  I went to a larger gas lens and a lot more tungsten stick out  and everything is going way better.  Chassis is almost done, engine almost ready for dyno. Need to make a call on my torque converter yet but should be ready for end of April.

Offline FED1965

  • Newbie
  • *
  • Posts: 10
    • View Profile
  • Your Best Time: none
  • Your Engine: 283 Chevrolet
  • Your Track: none
  • Your Vehicle: none
  • General Location: Winnipeg Manitoba
Re: welding ?
« Reply #16 on: February 28, 2016, 09:29:59 PM »
I use the Green Brakleen CRC 75088 I'm pretty sure it's NON chlorinated???? I hope so! I have used it for quite a long time it seems to evaporate right away. It seems good to degrease before painting. Is this stuff OK???