« previous next »
Pages: [1]   Go Down

Author Topic: transbrake not holding  (Read 4783 times)

Offline spookie

  • Jr. Member
  • **
  • Posts: 61
    • View Profile
  • Your Best Time: 8.92 1/4 5.59 1/8
  • Your Track: Quarter Aces drag-o-way
  • Your Vehicle: F.E.D.
transbrake not holding
« on: May 25, 2015, 04:46:41 AM »
Had PG trans rebuilt and transbrake would not hold at all.I have taken it apart and tighten rear clutch pack. {.082} Brake holds to 3500 rpm then will roll.Rebuilder used B&M clutches,good or bad?? Trans worked fine but for transbrake. My 1500lbs F.E.D. runs 5.60 in 1/8  8.80 in 1/4 so not much power. Checked press at servo 220psi.Need a little help!
Logged

Offline bikeguy307

  • Full Member
  • ***
  • Posts: 241
    • View Profile
Re: transbrake not holding
« Reply #1 on: May 25, 2015, 11:08:15 AM »
Sounds like the solenoid is not holding, or possibly the valve is not getting set in deep enough. I have seen a worn valve cause the same the problem. These are some things to check, also not sure what brand valvebody you are using but most all like a .050 to .070 clearance on the reverse clutch. Keep in mind I do not think the clearance is your problem.

Hope this help
Dan
Logged

Offline masracingtd1167

  • Hero Member
  • *****
  • Posts: 1138
  • bill masiello Shelton Ct.
    • View Profile
  • Your Best Time: 7.40's at 181 on motor 6.94 at 192 nitrous
  • Your Engine: 394 chevy
  • Your Track: Lebanon Valley Dragway
  • Your Vehicle: 2003 Neil and Parks
Re: transbrake not holding
« Reply #2 on: May 25, 2015, 02:46:55 PM »
Quote from: spookie on May 25, 2015, 04:46:41 AM
Had PG trans rebuilt and transbrake would not hold at all.I have taken it apart and tighten rear clutch pack. {.082} Brake holds to 3500 rpm then will roll.Rebuilder used B&M clutches,good or bad?? Trans worked fine but for transbrake. My 1500lbs F.E.D. runs 5.60 in 1/8  8.80 in 1/4 so not much power. Checked press at servo 220psi.Need a little help!
    Did the trans brake work before it was re built ? did the guy who re built it take the trans brake apart ? Some use a check ball some don't Some use special gaskets some don't ! I screwed one up once !It seems like every manufacturer makes theirs a little different i'm sure that Dan would agree .We had a solenoid fail on my sons car and it did the same thing . 
Logged

Offline bikeguy307

  • Full Member
  • ***
  • Posts: 241
    • View Profile
Re: transbrake not holding
« Reply #3 on: May 25, 2015, 05:09:13 PM »
It very well could be a gasket problem, leaking just enough to not hold solid. If the ball was missing it would apply the brake in rev. the ball is so it doesn't back feed low when in reverse on pro tree valvebodies.
Logged
Pages: [1]   Go Up
« previous next »