Author Topic: blown injected gas street sbc  (Read 7253 times)

Offline jeff/21

  • Full Member
  • ***
  • Posts: 186
    • View Profile
  • Your Best Time: 8.24
  • Your Track: any with-in a 6hr radius
  • Your Vehicle: fed
blown injected gas street sbc
« on: February 27, 2015, 04:15:52 PM »
My friend has been running a blown injected sbc on methanol on the street now wants to changed to gas. I know this isn't a race car. i had Kinsler set the injection up 20 years ago now i'm looking for someone to check and set it up for gas
sbc 406" 72cc brodex heads, Arias pistons 9.5-1, 6-71 blower Hilbourne hat, if you can or want to do it i'll ship it on monday or refer me to someone thank you

dreracecar

  • Guest
Re: blown injected gas street sbc
« Reply #1 on: February 27, 2015, 06:10:28 PM »
On alky you can be rich and will not affect much, But with gas it will have to really be rich at idle because it does not have a excellerator pump to get things going so driving around part throttle  will be tricky

Offline jeff/21

  • Full Member
  • ***
  • Posts: 186
    • View Profile
  • Your Best Time: 8.24
  • Your Track: any with-in a 6hr radius
  • Your Vehicle: fed
Re: blown injected gas street sbc
« Reply #2 on: February 27, 2015, 08:12:48 PM »
on alky the the only problem  was fueling when on a cruise now i'm working on updating his car changing cam lowering compression, increasing cooling  and now need the fuel system flowed and jetted for a starting platform to start from.and make sure everything is working properly

Offline ricardo1967

  • Hero Member
  • *****
  • Posts: 578
    • View Profile
  • Your Best Time: No full pass yet.
  • Your Engine: Alky SBC 400
  • Your Track: Brown County Dragway (Bean Blossom, IN)
  • Your Vehicle: 173" FED
Re: blown injected gas street sbc
« Reply #3 on: February 27, 2015, 08:15:30 PM »
Being a street car, I'd convert it to EFI.

Offline jeff/21

  • Full Member
  • ***
  • Posts: 186
    • View Profile
  • Your Best Time: 8.24
  • Your Track: any with-in a 6hr radius
  • Your Vehicle: fed
Re: blown injected gas street sbc
« Reply #4 on: February 28, 2015, 12:26:08 AM »
the guy works on efi everyday and wants to keep it mechanical

dreracecar

  • Guest
Re: blown injected gas street sbc
« Reply #5 on: February 28, 2015, 09:21:16 AM »
Before Id start changeing things on the engine I would gather more info on the fuel system, its a delicate balence and may be more trouble then just running out of fuel at a local cruise. The most successful versions have been a gear drive timing set and a hollowed out 6/71 case with a carb inside.  Have at it and wish you a lot of luck

Offline wideopen231

  • Hero Member
  • *****
  • Posts: 1910
    • View Profile
  • Your Best Time: 1/8 3.70@ 198 1/4 5.78@245
  • Your Engine: Hemi 526 ci alcohol
  • Your Track: Piedmont
  • Your Vehicle: 225 CMC FED
  • General Location: NORTH CAROLINA
Re: blown injected gas street sbc
« Reply #6 on: March 03, 2015, 11:03:51 AM »
I have done 3 of these on gas for street guys. While its workable the milage between gas stops sucks big time,mainly due to rich idle. I agree 100% that going to efi is the way to go. If guy works on EFI it should be snap for him.
Relecting obama is like shooting right foot because it did not hurt enough when you shot left foot

Offline Spud Miller

  • Global Moderator
  • Sr. Member
  • *****
  • Posts: 332
    • View Profile
    • Fuel Injection Ent., LLC
Re: blown injected gas street sbc
« Reply #7 on: March 04, 2015, 06:36:54 AM »
 Injected gas on the street is the worst possible combo. Very twitchy and sensitive. Generally either wheezing through the intake or belching black smoke at partial throttle...it's always wrong. If he puts an O2 sensor and AFR meter on it, at least he'll have a clue which way to go and by using several different bypass methods, may be able to get it close half the time. A dial-a-jet up through the floor to change pills on the fly for different cruise speeds is a popular way to try to conquer this.

 Spud
 

Fuel Injection Enterprises, LLC
     Mechanical Injection
     Magnetos
     EFI Conversions

Offline Pinto289

  • Newbie
  • *
  • Posts: 1
    • View Profile
  • Your Track: Island Dragway
  • Your Vehicle: Ford Mustang
Re: blown injected gas street sbc
« Reply #8 on: March 08, 2015, 06:38:46 PM »
Any of you guys ever see these videos or heard of Instajet? 
   
             
I stumbled across this guy he seems to have pretty good luck running injection on the street. His car seems to run very well, might be worth looking into. It appears to be an electronic version of dial-a-jet. This would probably keep your hands freed up for driving.
« Last Edit: March 08, 2015, 06:42:26 PM by Pinto289 »