Author Topic: What did you do on your Junior Dragster TODAY?  (Read 23068 times)

Offline GlennLever

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 2058
    • View Profile
    • The Lever Family Site
  • Your Best Time: 1/4 mile 7.950 at 165 MPH
  • Your Engine: Pontiac 461 Alky Blown
  • Your Track: Empire Dragway, NY
  • Your Vehicle: Front Engine Dragster
What did you do on your Junior Dragster TODAY?
« on: September 20, 2014, 08:50:26 PM »
What did you do on your Junior Dragster TODAY?
Glenn R. Lever
Rochester, New York 14617-2012
My Cars

Offline Goinbroke2

  • Newbie
  • *
  • Posts: 12
    • View Profile
  • Your Best Time: 12.48@110
  • Your Track: Greenfield NS
  • Your Vehicle: 83 Mustang GT
Re: What did you do on your Junior Dragster TODAY?
« Reply #1 on: March 20, 2016, 08:15:54 AM »
Walked by it shaking my head knowing I have a ton of work to do before the season opens and even though the kid is "c'mon dad" I've been working 70+ hours a week and can't help sucks....I'm actually writing this on the work computer, today being Sunday 12:15.....

So far though....I did change the tie rod ends and front left wheel bearings and re-installed the battery. The big job though is fabbing up a complete aluminum plate for the new (to me) polar clutch and 3/4 shaft/bearings/etc. Currently it's running an old style TAV-30 clutch which seriously sucks but it was enough to let the kid race for the last 4 years. just waiting 2 more years until he turns 16 and can drive a full size car which will be dirt cheap compared to these! LOL!

Anyway, people are starting to show up for my meeting, better get back at it....blah....

Offline Goinbroke22

  • Newbie
  • *
  • Posts: 2
    • View Profile
  • Your Track: Greenfield dragstrip
  • Your Vehicle: 83 mustang GT
Re: What did you do on your Junior Dragster TODAY?
« Reply #2 on: January 29, 2019, 06:32:15 PM »
What did I do to it? Nothing! Sold it last spring and the kid is driving a focus until he gets a real race car built. (My idea actually, start him in sportsman/street class)

Paid $2000 for it and raced it 7 years then sold it for $1700. (Probably spent an easy $4000 in that time replacing engines lol)


  • Sr. Member
  • ****
  • Posts: 360
    • View Profile
  • Your Best Time: 8.28@168 door; 9.00@147 6-cyl alt; 8.53@160 RED
  • Your Engine: 300 Ford six NA w/ crossflow and prod. heads
  • Your Track: Milan, Thompson
  • Your Vehicle: (3) Advanced Chassis altered , The Last Logghe altered, '30 RPU
  • General Location: North Coast
Re: What did you do on your Junior Dragster TODAY?
« Reply #3 on: January 30, 2019, 06:51:18 AM »
(Probably spent an easy $4000 in that time replacing engines lol)

My next door neighbor had a nice Junior his kid outgrew. He said "take it and use it with your grandkids". I said,"OK thanks", but gave him back the alcohol burning billet engine saying "I don't want to blow this thing up and have to buy you a new one".
I got an old B&S rototiller 5 hp engine, converted it over to J/D  use with a Honda carb and header pipe. It only runs 14s but the grandkids have a blast going out to the track with "Racing Grampa". It still has a recoil rope starter and I pull it with an old garden tractor I souped up. Quite the contrast between the golf cart driving, aircraft startered alcohol burning seven second Juniors around us, but fun nevertheless.
« Last Edit: January 30, 2019, 06:55:19 AM by THE FRENCHTOWN FLYER »

Offline racerken

  • Jr. Member
  • **
  • Posts: 52
    • View Profile
  • Your Best Time: 8.76 1/4 mile (FED)
  • Your Track: State Capital Raceway
  • Your Vehicle: FED
  • General Location: Baton Rouge La
Re: What did you do on your Junior Dragster TODAY?
« Reply #4 on: January 30, 2019, 12:07:28 PM »
The way it was meant to be, until the mighty dollar got involved,  like all of drag racing.  Glad you guys are having fun and not spending your retirement fund racing.

Offline Goinbroke2

  • Newbie
  • *
  • Posts: 12
    • View Profile
  • Your Best Time: 12.48@110
  • Your Track: Greenfield NS
  • Your Vehicle: 83 Mustang GT
Re: What did you do on your Junior Dragster TODAY?
« Reply #5 on: February 01, 2019, 08:33:38 AM »
So....being cheap that I am, I did the $$$ on the briggs engine the first year or two and then had an epiphany. Briggs and the Chinese knock off Honda clones were actually exactly like 1955 all over again.
Flat head ford, Poor breathing, 85hp and could be built (with enough $$) to 200hp
sbc, good breathing and came factory with 200hp

Flathead, 3 mains, low rpm
sbc, 5 mains, high rpm

On and on it goes. Well lets compare the briggs;
Briggs, poor breathing flathead, = need to extensively port and relieve,
above 5000 the dipper breaks off the con rod = need billet rod
5000+ the con rod or piston breaks = billet rod and forged piston
5500 the cast fly wheel explodes = billet flywheel
to go above 5500 need cam with more lift so you need to notch the head or go billet = cam/springs/gears/billet head
6000 the side plate flexes and breaks = billet side cover with roller bearing on both ends of crank
7000 the crank breaks so you need a support bearing on the end of the crank by the clutch
8000 (or over boring) the jug blows off = billet jug/head support
Most are "cool bore" which means aluminum cyl which nobody around here can bore/hone
Everything for briggs racing is EXPENSIVE! (Craws in NY "freshens" a friends engine for $5000....FRESHENS!!

Honda clone;
Cast iron liner
Roller bearing on both ends of crank
good breathing overhead valve head
Honda flywheel will take 7000rpm
Karts use the engine so everything is available and CHEAP!!

So, I went to princess auto (Canadian version of harbour freight) and $99 for a 5hp clone.
Karts Canada sold me the "head combo # 3" for $200 or so. SS valves, 26# springs, heavy guide plates, pushrods, some other stuff I forget
Dyno cams sold me a cam for $60 (2500 - 7000)
Made my own intake and bolted the 28mm flat slide alcohol mikuni on and picked up a full second over the previous briggs combo that was WAY more expensive and WAY more "on the edge" (the briggs he blew up which initiated this said 12,200rpm on the data recorder, it normally went through the lights around 9500)
The clone hit 7000 in the 1/8th. We went to a test and tune weekend and were the only junior there, treated like royalty but they were set up for 1/4 mile and didn't want to switch back and forth. The kid held it wide open about 30 runs that weekend, hit 7100 and stayed there the rest of the pass. Poor motor was screaming for 21 seconds or so, not sure if floating valves or just couldn't breath anymore but never hurt it a bit!

Ran that clone engine the last 3 or 4 years and never did anything more that change the oil.
Gas, it slowed a second or so but went through maybe 2- 3 litres a weekend. Oil was fine but changed it at the end of the weekend.
Alcohol (actually I used methyl hydrate, cheaper and available everywhere) Ran Fri night, change the milky oil out. Ran Sat, change the milky oil out. Ran Sunday, change the milky oil and strip the carb and spray it full of wd-40. Total was 8 litres of meth for the weekend.

So, if you're running a briggs and the kids are having fun, fine. Once they get the "I want to go faster like them" then pull the briggs and get a clone. Clutch fits on the same even.
The clone will pick up a bit over the briggs all else equal, but a home made header/mikuni carb (gas or alcohol) and it will be low 13's or high 12's. That will last them for another 2-3 years. If you want more than that, go to "affordable" and get a cheap cam/head package and run 11's. For 1/4 of the price it would be for a briggs.

I kept the kid to low 11's just because I didn't want to spend more to go faster when he was starting to win fairly regularly.
Had a blast, great 7 years and we bonded, race weekend was him and me in the motorhome. Mom and the oldest had no interest so they didn't go. Had a routine of stopping for McDonalds on the trip there and ice cream on the way home. Excellent years and I know he'll remember for the rest of his life.

(still think I should of taken more pictures though, realise now you can't have to many of when you're young...)

Edit: forgot to add, kid thought he was running top fuel the whole time, strutting around after a round win with the arm restrains still on, talking about "whomping the throttle" freaking hilarious! His 2nd last race in the junior was a big weekend with 3 races due to rain outs. He won two of them and runner upped in the third. Left with $600 or so in his pocket. (course it cost me $250 a weekend to get the motorhome there and back....but I
« Last Edit: February 01, 2019, 08:41:58 AM by Goinbroke2 »